Command Communications ComSwitch 8500-t Informations techniques télécharger pdf (Page 40)

G2T Programmers Guide Rev-A 17-Nov-2014

5.2.2.7. LOCk and UNLock commands

These commands allow the user to lock and/or unlock the front

panel keypad.

LOCk nnnn (any number from 1 - 9999)

UNLock

Use the lock and unlock commands as necessary. The code is not

required to unlock the keypad remotely. Sending UNLock returns

the front panel status to unlocked.

examples:

• LOCk 2121 locks front panel keypad with code 2121

• UNLock unlocks front panel keypad

5.2.2.8. ETHernet? command

This command is a query that returns the MAC address of the

processor board. It is a unique alphanumeric string of hexadecimal

numerals arranged as six (6) octets separated by colons.

example:

ETH?

Might return a string like this (without spaces):

1 2 : 3 4 : 5 6 : 7 8 : 9 a : b c

 NOTE: Each controller module has a unique MAC address. If

the controller module is changed or replaced, the MAC

address changes.

5.2.2.9. *SAV and *RCL commands

These commands allow the user to save and recall complete

switchpoint configurations in non-volatile memory locations in the

system.

*SAV memory

*RCL memory

The user can save and recall complete switchpoint configurations.

As a departure from 488.2, however, 0 is not acceptable. The

highest number that is acceptable can be found by the GET? 28

query.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 108 109

Pas de commentaire

Command Communications ComSwitch 8500-t Informations techniques Page 40